Everyday Calc Notes Calculators & Mini Games

Percentage Increase/Decrease Calculator

Compare the old and new values to instantly see how much they increased or decreased.

The numbers below are just examples. Change them to fit your situation.

We don't save the numbers you enter.

How much do you need?

Enter a number
to see how much you need.

Change the values on the left and click Calculate.

HOW TO USE

How to Use

  1. Enter the previous value to use as the baseline.
  2. Enter the new value.
  3. Check both the direction (increase or decrease) and the percentage.

What to Do in This Situation

Going from 100 to 120 is a 20% increase. Dropping from 120 to 100 is about a 16.67% decrease.

How Is This Calculated?

Percentage change = (New value − Previous value) ÷ Previous value × 100. A previous value of 0 cannot be entered because the percentage would be undefined.

Change conditions to compare

If it goes up 20% and then down 20%, is it back to the original value?

Increases and decreases use different denominators. Even if the amount of change is the same, the percentage changes when the baseline shifts.

The following is a hypothetical example. Check all the conditions under 'Expand Inputs' and adjust them to fit your situation.

100 → 120

Increase Rate
20 %
Increase
20
Percentage of previous value
120 %
Expand Inputs
  • Original value: 100
  • New value: 120

120 → 100

Decrease Rate
16.67 %
Decrease
20
Percentage of previous value
83.33 %
Expand Inputs
  • Original value: 120
  • New value: 100

What to Check Before Entering Values

Next Steps Based on Your Results

To return to your target amount, don't just subtract the percentage it went up by—you need to recalculate using the new amount as your baseline.

Everyday Calc Notes · Updated 2026-10-15. Example results were generated using the calculation engine on this page. Purchasing a product does not affect the calculations.

FAQ

FAQ

Why are the increase and decrease percentages different?

Because the denominator (the previous value) is different in each case.

What if the previous value is 0?

A percentage divided by 0 is undefined. In this case, compare the absolute change instead.